How to fix the cable tray insert plate

Secure the insert plate using FRS M6 truss-head bolts and combination nuts, ensuring proper alignment and torque to maintain tray stability and protect cables.

Step-by-Step Instructions

1. Prepare the Tray Sections Ensure the cable tray sections are properly aligned and supported. Check that the ends are clean, free of burrs, and, if cut, re-drill any connector perforations as needed . Use edge protection strips on cut edges to prevent cable damage if no joint plate is installed . 2. Position the Insert Plate Place the insert (joint) plate centrally over the joint area of the two tray sections. The plate should sit flush with the tray edges to maintain a straight and level alignment . 3. Fasten the Plate Insert FRS M6 truss-head bolts through the holes in the insert plate and the tray rails from the inside of the tray. Secure each bolt with a combination nut on the outside of the tray to prevent loosening due to vibration . Ensure all bolts are tightened evenly. 4. Torque Control Use a torque wrench to apply the recommended torque for M6 bolts. Proper torque ensures long-term stability and prevents joint failure or sagging under load . 5. Check Alignment and Stability After fastening, verify that the tray sections are level and aligned. Adjust if necessary before adding cables. Ensure the joint is firm and does not allow movement . 6. Optional Quick Connect Systems For faster assembly, some systems allow snap, slide, or twist connections that reduce installation time. These may require fewer tools but are often brand-specific . 7. Safety Precautions Always pass screws through the rail from the inner side to avoid damaging cables. Wear appropriate PPE and follow local electrical and mechanical safety standards . By following these steps, the cable tray insert plate will be securely fixed, maintaining system stability, safety, and ease of future maintenance .